View Single Post
Old 04-13-2009, 05:43 PM  
Pleasurepays
BANNED - SUPPORTING TUBES
 
Join Date: Aug 2002
Location: I live in a pile of boogers
Posts: 11,913
http://www.civil.usyd.edu.au/wtc.shtml
is that objective enough for you? or is the Civil Engineering Dept of the University of Sydney in on the massive US Conspiracy led by the worlds dumbest world leader?



The fire wasn't hot enough to melt the steel

There has never been a claim that the steel melted in the fire before the buildings collapsed, however the fire would have been very hot. Even though the steel didnt melt, the type of temperatures in the fire would have roughly halved its strength.

There would have been variations in the distribution of the temperature both in place in time. There are photos that show people in the areas opened up by the impact, so it obviously wasnt too hot when those photos were taken, but this is not to say that other parts of the building, further inside were not hotter. In addition, to make a reasonable conclusion from these photos, it would be important to know when they were taken. It might be possible that just after the impact the area wasnt very hot, but as the fire took hold the area got hotter.


The way the building collapsed must have been caused by explosions

One demolition expert on the day of the collapse said it looked like implosion but this is not very strong evidence. Implosion firstly requires a lot of explosives placed in strategic areas all around the building. When and how was this explosive placed in the building without anyone knowing about it. Second, implosion required more than just explosives. Demolition experts spend weeks inside a derelict building planning an event. Many of the beams are cut through by about 90% so that the explosion only has to break a small bit of steel. In this state the building is highly dangerous, and there is no way such a prepared building could still be running day to day like WTC was.


Why did the building fall so quickly?

The buildings did fall quickly - almost (but not exactly) at the same speed as if there was no resistance. Shouldn't the floors below have slowed it down? The huge dynamic loads due to the very large momentum of the upper floors falling were so great that they smashed through the lower floors very quickly. The columns were not designed to carry these huge loads and they provided little resistance.

What about World Trade Center 7?

I have not studied WTC in any great detail and cannot offer any theories on its collapse mechanism. In the chaos of the day, little attention was paid to WTC7, so there is less evidence available on the damage it sustained before it collapsed. However, some questions that you may want to ponder ...
* While it did not receive any direct impact form the planes, how much debris hit at as the main towers collapsed and what damage did it cause?
* To what extent (if any) did the shock or vibrations caused by the collapse of WTC1 & 2 affect the integrity of WTC7?
* Did any unseen damage to the WTC7 foundations occur in the collapse of WTC 1 & 2?
* Did any of the fire suppression systems in WTC7 function?
Pleasurepays is offline   Share thread on Digg Share thread on Twitter Share thread on Reddit Share thread on Facebook Reply With Quote